Answer / guest

Answer: C

The 802.2 Frame Type is the default frame-type for Netware 3.12.

Define topology?

0 Answers  

---

What are two characteristics of the RARP protocol? (Choose two) A. it generates parameter problem messages B. it maps IP addresses to Ethernet addresses C. it maps Ethernet addresses to IP addresses D. it is implemented directly on top of the data link layer

1 Answers  

---

After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1

2 Answers  

---

what is difference between hub and switch?

7 Answers   IBM,

---

Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?

0 Answers  

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any

1 Answers  

---

How IEEE Calculate the Cost of Link (ex.. 10mbps is having Cost 100) Is there any formula or any test to calculate it.

2 Answers   IBM,

---

Station A is transmitting data to station B faster that station B can handle it. When station B's buffer fills up, it send out a message to station A to stop sending data. After B empties out its buffer, station B sends a message to station A to start sending data again. This is most directly an example of (pick the best answer only): A.) Poison Reverse B.) Connectionless protocol C.) Windowing D.) Connection oriented protocol E.) Flow Control F.) Split Horizon

1 Answers  

---

The CSMA/CD Ethernet IEEE committee is defined as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

2 Answers  

---

Which command displays the IP addresses assigned to specific host names? A. show hosts B. show interface C. ping host name D. config host name E. show host mapping F. show host ip address G. trace ip addresses host name H. a partridge in a pear tree

2 Answers  

---

Difference between subnetting & Vlan??

7 Answers   Cisco, TCP,

---