How many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers  

---

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

3 Answers  

---

HI friends. i need a suggestion and looking towards you foryours valuable suggestion friends i have completed ccna now i want to done red het linux system admnistration and networking i am liitle bit confuse betwwen them which one is better for me for job point of view reply soon waiting for your reply

1 Answers  

---

Which of the following is not a characteristic of link-state routing protocols? ❍ A. VLSM support ❍ B. Route summarization at any bit level ❍ C. Full routing updates at regular intervals ❍ D. Discontiguous network support

2 Answers  

---

what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  

---

Which port are used by Viruses? TCP or UDP?

8 Answers  

---

Explain how an spf algorithm works?

0 Answers  

---

What is default size of hello packets in ospf?

0 Answers  

---

Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated

5 Answers   Cisco,

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission

1 Answers  

---

How convergence happen in ospf?

3 Answers   TCS,

---