please give detail procedure how do replace failed disk
under control of SVM and VxVm
Answers were Sorted based on User's Feedback
Answer / hyma
First try to enable the disk using metareplace command. if
it's failed check format command the disk drive is
avaliable are not.If it is not avaliable means needs
replacement of the bad disk.
once 3rd party venders replace the new disk.
1st check format command if it is detected or not. its not
dected means using devfsadm commnd. After that try to
resync the data using metareplace command.
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / nitesh bhope
by using metareplace command we can replace the failed or
curropted volume
Is This Answer Correct ? | 3 Yes | 7 No |
Answer / srinath
we can configure the ht sapepool then one disk is corupted
then automtically replace the another disk
Is This Answer Correct ? | 2 Yes | 9 No |
Whats the difference between SVM and VxVM? What would you recommend to your clients? why?
How to merge solaris partition
what is the disadvantage of 'tar' command?
booting process in solaris
13 Answers IBM, OMS, Wipro,
how can u create aggregate
I have an interview in Qatar Petroleum for Solaris System Engineer position. Please provide all the technical questions about Solaris OS.
how will u create user with out asking a password?
what is port no for NFS?
what is state database replica and how to create it
what is file system ?can u explain briefly ?
In TOP command, can you please explain what is the three numbers reported as part of the load average output "load average: 11.57, 9.84, 8.26"
If a user logs in to UNIX, it displays the desktop and then immediately logs you back out, what could be wrong?