Sequence and acknowledgement numbers are used for?
A.) Layer transitioning
B.) Flow control
C.) Port number addressing
D.) Reliability
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D
TCP uses sequence numbers and acknowledgements to implement
reliability.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / norbac
to make transmitions of packets between two hosts more reliable
Is This Answer Correct ? | 1 Yes | 0 No |
I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?
Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp
What are 10base2, 10base5 and 10baset ethernet lans?
Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash
Which addresses are INCORRECTLY paired with their class? A. 128 to 191, Class B B. 192 to 223 Class B C. 128 to 191, Class C D. 192 to 223, Class C
What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile
Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!
let threr are three router 1 is cionected to two and two is conected to three that is 1----2----3 now we can ping 2 from 3 and 1 to two but we are not able to ping 1 to 3 let router 1 is local and rest of two are remote what should be urs troubleshoot steps
How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three
as we know that isdn bri port come with either a u interface or some thing s/t interface what is the diffrenmce between them
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled