What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
640Post New Electrical Engineering Questions
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
previous year paper of ntpc bhel for degree in electrical enng
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
can u give me a brief idea about power line carrier communication ??
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
What is the relationship between voltage,current & frequency?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
What is difference between isolator and circuit breaker?
why the rotor current becomes in steady state during high slip region? please verify with equations.