Mechanical Engineering Interview Questions
Questions Answers Views Company eMail

WHY DOES LORRY TANKERS DESINGNED TO BE IN SPHERICAL(CURVED,ROUND), WHY DOESNOT IT DESIGNED TO BE AS SQUARE OR REACTANGLE IN SHAPE.

APSRTC, Schlumberger,

5 8828

How to handle production department ?

Kirloskar,

758

what is the responsibility of production department ?

1 4718




How to reduce prodction assembly time ?

2 2658

how to handle manpower in production department ?

Jakraya Sugar,

6 38499

what is application of portable generator?

1 1788

WHAT IS THE DIFFERENCE BETWEEN IMPACT FORCE & SUDDEN FORCE.TELL ME WITH EXAMPLE IF YOU KNOW

2 5201

What is meaning of due point in air Compressor system?

1 2588




why a diesel generator gives less fuel consumption which has a mechanical governer compared to auto governor

L&T,

1 2906

what is different between runout and concentricity in Gd&T

NRB Bearings, Quantum, Sunder Industries,

7 67382

Hello sir I am going to give section engineer examination and will be held in 2010. So I need all prevous years examination papers. please send it on my email id : bhalchandrap@yahoo.co.in

664

A BEARING IS DESINED AS 6205. WHAT IS IT"S BORE DIAMETER?

4 4772

ADVANTAGE &DISADVANTAGE OF USING LPG IN CAR?

MAHINDRA,

898

function of clutch?

3 3543

how a disel engine works in generator? explain with labelled diagram?

2 6119


Post New Mechanical Engineering Questions






Un-Answered Questions { Mechanical Engineering }

How much should be the minimum and maximum suction and discharge pressure of screw chiller plant.

1436


a three phase squirrel cage induction motor runs slow? list all possible reasons for such fault.

747


what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.

701


what is the diffrence betwen primary pumps and secondary pumps in aircoditioning field

814


define material grades 15b25,10b21,scm-415,16mncr5 in detailwith their compositions

7574






Hiii.. i have applied for steel plant management trainee 2010 exam for stream mechanical... the pattern of the exam has changed.. a preliminary exam which consists of the engineering basics... can any one suggest any book for this... kindly respond to this...

701


how much efficiency loss will tool place in a steam turbine due to low vaccum?

764


which type feect in generator and turbine in reverse power protection

838


Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?

714


We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.

746


PLEASE PROVIDE ME PAPER ALONG WITH QUESTION THAT ARE ASKED IN ENTRANCE EXAM EVERY YEAR/

553


can any1 provide me the PLACEMENT PAPERS FOR BHEL

882


What are you going to inspect or check when you open the crankcase?

812


what happens at an equipment buyoff?

1181


What is short cycling in refrigeration system?

1637