how much fuel is consumed on full load for a 500KVA Diesel Generator in one hour.5 10262
what are the resorces and equipment for measurement and how we can defiend Measurement.2 2715
EXPLAIN THE DIFFERENCE BETWEEN BENCH VICE AND PIPE VICE?2 10458
what is differences between welding & brazing?2 3356
WHY ISOMETRIC VIEW LOOK LIKE 3D?4 5332
why we maintain turbine rpm always more than what we need to run generator in thermal power plant2 3594
how determine the capacity of refrigeration system? how we use condenser coils, compressor, capillarity,compressor1 2415
How conduct the hydro & pnumatic tests of Pressure vessels as per ASME & as per EN Standerds.3 6792
How to conduct the Hydro & Pnumatic test as per DIN & ASME sTANDERS?1 2546
What is difference between ASME EN & IS related welding procedures(WPS/PQR/WPQ)2986
what s available NPSH and required NPSH? which is given by manufacturer and which is not? what is the role of customer in choosing NPSH?
In d thermal power plant why D/A placed on height.4 3623
HELLO SIR VERY GOOD EVENING SIR,
I'M KALAMANI. I NEED TO PREPARE FOR
UPCOMING "JINDAL STEEL AND POWER LTD" INTERVIEW. I'M
MECHANICAL ENGINEER SIR. SO PLEASE SEND ABOUT JINDAL's
PREVIOUS APTITDE TEST QESTION PAPERS TO MY MAIL ID :
plz get me the placement paper for the hindalco industries Ltd. plz mail it on email@example.com
hi, if anyone have previous year paper of NHPC or some questions, Please send me at firstname.lastname@example.org
explain the mixture requirement of si engine to meet the demands of various operating condition?
what is the use of choper motor in pyrometer ?
How do concrete pumps work?
how much stack emmission through your chimney & what is the state govt. norms.?
What for pyranometer is used ?
how we calculate the induced air capacity of id fan of a boiler?
Sketch the jacket cooling system?
What is a process flow diagram?
State fresh water generation plant made water flow.
Do you need to be an apprentice for mechanical engineering?
Why is it that the maximum value which the residual stress can reach is the elastic limit of the material ?
during the design of a friction clutch what are the considerations that should be made?