In what conditions it is necessary to trip the boiler? what about burner in these conditions?1 1741
what is the difference between fire grate in a boiler and the burner? and is the fire grate is the furnace of the boiler?682
IN POWER PLANTS NORMARLY BOILER DRUMLEVEL TRIPPING GIVEN AT 20% OF WATER BUT WHY NOT THEY GIVE AT 0% OF WATER?2 2365
IN 6" PIPE IF FEED WATER FLOW IS ABOUT 130 T/H SO SAME DIAMETER OF PIPE HOW MUCH STEAM FLOW SHOUD BE?622
WHAT IS THE PLANT HEAT RATE AND WHAT IS THE TURBINE HEAT RATE?
ONE TURBINE HAVING THREE EXTRACTIONS AND ANOTHER HAVING ONE EXTRACTION WHICH TURBINE IS MORE EFFECIENCY?2 1896
What is the use of a PULLEY?12 8485
why the rail in form of I-beam?1 2680
When ship enters sea from a river one can expect it to rise or sink?2 4475
Why stress-strain diagram is not prepared by compressive testing instead of testing component by tensile stress?2 2610
There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?
tell me about a type when you had to use your presentation skill to influence some ones opinion
What are the defects in exhaust valve?
pls send me rechnical test paper of reliance with answers for last five years??
Cox chart is used in ....Distillation, evaporation, drying
What are the usual checks when induction motor is running?
why stress relieving of stainless steel is not preffered
as started in the job offer notification, is our basic salary of 1lakh good for you if employed?
what is first law of Thermodynamics ? What is second law of Thermodynamics ?
what is the difference between under vacuum & under pressure boiling?
what is procedure of measuring operating length of mechanical seal.(in case of centrifugel pump)
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
what is the difference between impact force and sudden force? pls give any example.
NOW IAM WORKING QUALITY ENGG ONSHORE ...HOW CAN I CHANGE MY WORK INTO OFFSHORE ? NEED ANY QUALIFICATION ? PLEASE EXPALIN TO ME .....
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.