intial information of packey occur on which layer application sessions physical mine answer physical
1 3700which term use to allow user to conect the remote n/w with ppp dail up conection ras sap sonet mane answer rsa
1 3517Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -
1 4278When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
2 7148Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
3 5125let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.
1 3634Write an access list line which will deny node 20.0.2.1 to anywhere on your network using DNS via UDP. Don't worry about the other access list lines.
2 4438You have OSPF traffic flooding your network via one of your router interfaces. Write the access list line that will deny all ospf traffic. Don't worry about the other lines of the access list.
1 4468
On which mode we give debug command?
in stead of 0.0.0.0 wild card mask what u can write after ip?
What are 10baset ethernet lans?
Can you explain different components in PKI?
How do you configure a cisco router for routing ipx?
On which layer does L2F, PPTP and L2TP operate?
what is Bandwidth capping
What does the meaning of interface 0/0?
Is hub intelligent device?
Explain the difference between routing and routed protocols?
Explain the difference between flsm and vlsm?
What is difference between igp and eigrp?
Explain how many types of ips?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
Explain the difference between bus topology and hub?