Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 1 characteristic of RARP? A.) MAC to IP address translation B.) Connectionless delivery of packets C.) Can be used to initiate remote O/S load sequence D.) Generates error and control messages
5 10481Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) TCP B.) Ping C.) IP D.) CDP E.) Telnet
1 3901LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server
2 7687Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols
3 5093Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
1 3793Identify the default encapsulation on serial interfaces? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP
2 5580Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address
3 7195What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network
1 4034Identify 3 characteristics of the Network layer (OSI layer 3)? A.) Connnection oriented B.) Path determination C.) Supports multiplexing D.) Manages sessions E.) Packet forwarding
1 5261Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains
1 5627Which OSI layer handles physical addresses and network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network
2 8697Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
1 4804Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
1 5403Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Automous system number E.) Link state
1 5103Identify 2 features of PPP CHAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) Less secure then PAP D.) Local router 'challenges' the remote router
1 5505
What is the easiest way to remotely configure a router?
Can you explain PPP packet format?
Explain the types of communication in ipv6 ?
What is passive topology in ccna?
What is the igp (interior gateway protocol)?
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
Utilizing RIP, what is the limit when it comes to the number of hops?
Which command we give if router ios stucked?
Differentiate Logical Topology from Physical Topology
What is a network subnet?
Which dynamic type draw back is, if single link down, it removes its routing table?
Differnce between the communication and transmission?
Explain what is eigrp?
What is the difference between unicast, multicast, broadcast, and anycast?
Which way of communication bus topology use?
