"sap" is used by the Cisco IOS for which encapsulation types? A. Ethernet_802.2 B. Token-Ring C. FDDI_SNAP D. Ethernet_802.3 E. FDDI_802.2
1 4003Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
1 6694Which type of Ethernet framing is used for TCP/IP and DECnet? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
1 5800You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.
1 4518NetWare IPX addressing uses a network number and a node number. Which statements are true? A. The network address is administratively assigned and can be up to 16 hexadecimal digits long. B. The node address is always administratively assigned. C. The node address is usually the MAC address. D. If the MAC address is used as the node address, then IPX eliminates the use of ARP.
1 4000Which NetWare protocol works on layer 3--network layer--of the OSI model? A. IPX B. NCP C. SPX D. NetBIOS
1 6278As a system administrator, you want to debug igrp but are worried that the "debug IP igrp transaction" command will flood the console. What is the command that you should use? A. debug IP igrp event B. debug IP igrp-events C. debug IP igrp summary D. debug IP igrp events
1 5464What does the following series of commands accomplish? router igrp 71 network 10.0.0.0 router igrp 109 network 172.68.7.0 A. It isolates networks 10.0.0.0 and 172.68.7.0. B. It loads igrp for networks 109 and 71. C. It disables RIP. D. It disables all routing protocols.
1 4951In the command "router igrp 109" what does 109 signify? A. an autonomous system B. any network number which the router is attached to C. the allowable length of the routing table D. the network socket number
1 6417IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
1 3876IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds
1 6702The command "show IP protocol" displays which information? A. routing timers B. network information C. contents of the IP routing table D. information about all known network and subnetworks
4 19634An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only
1 7493
Name the protocol which can do load balancing on unequal cost also?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha
Explain types of communication in ipv4?
What is the difference between switch, routers, and hub?
What are 10base2, 10base5 and 10baset ethernet lans?
What is the difference between bus topology and hub?
What is the draw back of eigrp protocol?
In which protocol supenetting is enable by default?
What is poe (power over ethernet)?
What is icmp protocol?
What are the advantages of lan switching?
what is the matric of EIGRP protocol?
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
What port does rip use?
What is difference between flsm and vlsm?