Answer / guest

Answer:: C

Ethernet 802.3 is used with NetWare versions 2

through 3.11, Ethernet 802.2 is used with NetWare 3.12 and

later plus OSI routing, Ethernet II is used with TCP/IP and

DECnet, and Ethernet SNAP is used with TCP/IP and AppleTalk.

can anyone tell me which r the companies hiring freshers ( ccna ) in mumbai

1 Answers   HCL,

---

Which of the following are examples of ICMP? A.) Traceroute B.) Web Browsing C.) Ping D.) Telnet E.) Destination Unreachable message from a router F.) Inverse Tunnels

1 Answers  

---

Brielfly explain the conversion steps in data encapsulation

0 Answers  

---

Significance of IP helper-address Command on SW? Is it necessary to put this command?

1 Answers   Accenture,

---

PLACE YOURS QUESTION HERE I ALSWYS BE HERE FROM 9 AM TO 6PM SO U CAN FIND YOUR ANSWER QUICKLY.IF I KNOW THEN ? JJIITTEENNDDEERRAA SSIINNHHAA

4 Answers  

---

The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers  

---

Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip

2 Answers  

---

HI friends. i need a suggestion and looking towards you foryours valuable suggestion friends i have completed ccna now i want to done red het linux system admnistration and networking i am liitle bit confuse betwwen them which one is better for me for job point of view reply soon waiting for your reply

1 Answers  

---

Name the protocol which can do load balancing on unequal cost also?

0 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  

---

A user device that connects to a DCE must be which of the following? A.) DTE B.) CPE C.) Demarc D.) DCE E.) CO

1 Answers  

---