IGRP supports a feature that allows traffic to be
distributed among up to 6 (4 default) paths to provide
greater overall throughput and reliability. What is this
called?
A. unequal-cost load balancing
B. equal-cost load balancing
C. proportionate load balancing
D. low cost load balancing
Answer / guest
Answer: A
An unequal-cost load balancing is used to
provide alternate paths for data distribution on an
internetwork. Cisco developed this method to use unused or
under utilized links to increase bandwidth and network
availability.
| Is This Answer Correct ? | 1 Yes | 1 No |
What is the size of ipv6?
What are the 3 ways routers learn paths to destination networks? A.) Dynamic B.) Static C.) Routing tables D.) Default
Which OSI layer provides mechanical, electrical, procedural for activating, maintaining physical link? A.) Presentation B.) Network C.) Application D.) Physical E.) Transport F.) Data-Link
"arpa" is used by the Cisco IOS for which encapsulation types? A. Ethernet_II B. Ethernet_802.3 C. Ethernet_802.2 D. Ethernet_SNAP
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
The Internet Protocol (IP) occurs at what layer of the seven layer model? A.) Physical B.) Presentation C.) Network D.) Datalink E.) Session F.) Transport
Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session
What is the difference between csma/ca?
What is L2 Link and its significance regarding IP addressing.
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services
The Internet Control Message Protocol occurs at what layer of the seven layer model? A.) Physical B.) Transport C.) Session D.) Datalink E.) Presentation F.) Network
Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces