why water, methanol, ethanol ets solvents are used in UV
SPECTRIPHOTOMETER for blank reading ?
Answers were Sorted based on User's Feedback
Answer / chemdeep
usually the same solvent is used in uv for blank readings
that is used in the sample preparation.
Is This Answer Correct ? | 28 Yes | 6 No |
Answer / rama
If your medium is given solvents, then that solvents can be
used as blank other wise that can't be.
Is This Answer Correct ? | 17 Yes | 4 No |
Answer / nitesh pal
all that solvent not absorb uv light i.e not show absorbance in uv region
Is This Answer Correct ? | 3 Yes | 2 No |
Answer / nabil
Methanol for example absorbs at wavelengths below nm, and
water below 190 nm if we use methanol-water mix as a blank
we would have to use a wavelength grater than 205 nm to
avoid false reading.
Is This Answer Correct ? | 5 Yes | 8 No |
Answer / radha
they do not give any reaction with sample did n't give peaks
Is This Answer Correct ? | 7 Yes | 15 No |
What is differences between the Instrument and Equipment
why using factor 1.00639 in burette calibration of kf
which batch require to use for analytical method validation?
Principle of single pan analytical balance
0 Answers Amneal Pharmaceuticals, Bayer, Dr Reddys,
Which water can use Hplc analysis
9 Answers BioGenomics, Dr Reddys, Reddy Labs,
What is the major difference b/w Drift and Noise
4 Answers Aurobindo, Dr Reddys, Reddy Labs,
difference between selectivity and specificity
2 Answers Troikaa Pharmaceuticals,
why we are using in ph calibrations ph4,7,9.2 buuffers only?
3 Answers Reddy Labs, Unichem,
In UV-VIS spectrophotometer:My diluent is methanol even though i corrected base line for methanol,In my sample scan i found methanol peak.what is the reason?
What is the difference between known and unknown impurities?
What is Delay & Dead Volume
What is the principle of HPLC, GC, LCMS, GCMS,LC QQQ, GC QQQ, LC Q TOF and GC Q TOF. What are the applications and Specificity?