how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
1540If i have 200 test cases and we have to execute but we don't have time to execute all testcases.within 1 hour we have to execute that testcases and prepare the test report.so how i have to resolve this problem? is there is any technique in the testing.
3 4326The initial current is very large at the time of starting for almost all DC motors. SO WE USE STARTER FOR A SAFE STARTING but at our homes we don’t see any starters in our coolers, motors.WHY DON’T WE NEED STARTERS FOR THESE APPLIANCES?
1 2880Post New Electrical Engineering Questions
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
Installation method of self treated earth electrode.
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
How PSV sizing being done
What is servo motor and what are the applications of servo motor?
What happens if we run alternator on under frequency?
why we cannot protect 100% winding of an alternator by using differential protection?
What is the formulae of Megger value for a A.C.Motor
Why we use mho Relay in long transmission line?
how is the incoming cable size calculated for a given current rating of a panel??
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
how slip power recovery system work
