How do you derive the quantity of cement & sand in brick work construction in 1Meter cube, using CM 1:6 and bricks of size 19*9*9 cm
5 131391) what is the seewage discharge per person per day taken for design purpose as per IS codes? 2) how to convert gauge to MM like if we measure 18G as our door frame then how much is it in MM ? 3) how much binding wire is required ti tie 100kg steel ? 4) while making rings in steel reinforcement , whether the corners of rings are deducted to take out cutting length ? 5) how much carbon content should be there in steel used for construction purpose? 6) what are fe415 & fe 500 and which bars are used in general civil works?
1 5790fluid flow takes place due to its:- viscosity,comprssibility,surface tension,deformation undershear force
SSC,
3 17246whatis the minimum strength required for M-25 grade concrete in 14days compressive test? What is the procedure of calculation?
1 6165Post New Civil Engineering Questions
How many are the types of joints?
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
What is the significance of cost estimate knowledge for an architect?
what is conventional shuttering rate per square feet of built up area? what is Mivan shuttering rate per square feet of built up area? what is coupler shuttering rate per square feet of built up area?
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
How many types bend used in civil reinforcing
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
What is the different type of slump test indications?
How to fix toll charge for a particular vehicle at toll booths in a highway?
Define mirror?
Scaffolding IS code NO.
what is the criteria for the finalisation of pavement thickness in road project?
I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,
Can inverted beams used in pipes during construction?
what is the mode of method of face bar measurement