Tell me which cable we connect in db-9?
- 1 Answers
- 1159 Views
- I also Faced
- E-Mail Answers
Answer / Poonam Rani Chauhan
The DB-9 connector is typically used for RS-232 serial connections. To connect a device, you would use a DB-9 male-to-female or female-to-male cable depending on the device's gender requirements. For example, if your computer has a female DB-9 port and your device has a male one, you would use a DB-9 male-to-female cable.
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash
Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S
What are the two types of transmission technology available in ccna?
An ISDN BRI circuit can be described as which of the following? A.) 3B channels B.) 2-64Kbps B channels and 1-16Kbps D channel C.) none of the above D.) 2-64Kbps B channels and 1-16Kbps C channel
In how many ways you can access router?
What is the purpose of the Data Link?
Select the compression protocols for PPP? A. Stac B. Predictor C. Quality D. Magic Number
Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network
Which of the follow do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE
Why Authentication Header (AH) is not compatible with the network that using NAT?????? Jitu, looking for u specially...!!!! U knw why i m looking for u..!!!
Do we subletting of ip?
What is the easiest way to remotely configure a router?
CCNA 
