Which ISDN protocol prefix specifies switching and signalling?
A.) I
B.) E
C.) Q
D.) S
what is the difference b/w pap and chap,and give comand to configure pap cahp on two router r1 and r2,
What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.
how to find network ID from IP address?without using network calc...
12 Answers Idea, Karbon, NIIT,
Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config
Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing
What is the difference between OSPF Exteral Type 1 (O E1) & External Type 2 (O E2) routes????
Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp
How do areas benefit a link state inter network?
What is poe (power over ethernet)?
What does the following series of commands accomplish? router igrp 71 network 10.0.0.0 router igrp 109 network 172.68.7.0 A. It isolates networks 10.0.0.0 and 172.68.7.0. B. It loads igrp for networks 109 and 71. C. It disables RIP. D. It disables all routing protocols.
If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,
Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address