You want to set the console password to ralph. What would be the first command you need to execute from global configuration mode? A.) line console 0 B.) enable password ralph C.) login password ralph D.) set password= ralph E.) password ralph F.) login Ralph

1 Answers  

---

1 whatis te1,te2 and nt1 what is threre functions 2 what are the isdn protocols 3 whait is spid

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

2 Answers  

---

Explain the types of ethernet?

0 Answers  

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

---

What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs

4 Answers  

---

Explain the terms unicast, multicast, broadcast.

0 Answers  

---

Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version

1 Answers  

---

In the command "router igrp 109" what does 109 signify? A. an autonomous system B. any network number which the router is attached to C. the allowable length of the routing table D. the network socket number

1 Answers  

---

What is the difference between hub, switch, and router?

0 Answers  

---

State the difference between dynamic IP and static IP addressing?

0 Answers  

---

What does CCNA stand for? A. Cisco Certified Network Administrator B. Cisco Certified Network Associate C. Certified Circuitry in Networking Apprentice D. Calico Cats of North America

4 Answers  

---