Which three statements about common elements of the TCP/IP protocol stack are true? (Choose three) A. IP provides connectionless service and routing capabilities B. APP enables devices to locate the IP address of local devices C. UDP provides simple connectionless service without windowing or acknowledgments D. ICMP provides connection oriented management data to routers and Layer 3 switches E. TCP enables devices to send large quantities of data using windowing in a connection oriented manner

2 Answers  

---

Request any body to explain the parameters of Ipsec vpn tunnel while creating a tunnel in Cisco ASA.

3 Answers   HCL,

---

How many access lists are allowed per interface? A. One per port, per protocol B. Two per port, per protocol C. Unlimited D. Router interface +1 per port.

6 Answers  

---

Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities

0 Answers   Infosys,

---

In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to PAVRAM before becoming enabled

1 Answers  

---

What is subnetting and why it is use?

0 Answers  

---

Which command will show you if you have a DTE or DCE cable connected to an interface?

4 Answers   DFSS,

---

Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  

---

What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.

1 Answers  

---

Name the protocol which can do load balancing on unequal cost also?

0 Answers  

---

What is the difference between switch, routers, and hub?

0 Answers  

---

Identify the command to configure ALL the default VTY ports? A.) Router(config)# line vty 0 4 B.) Router# line vty 0 4 C.) Router(config)# line vty D.) Router(config)# line vty 0

2 Answers  

---