What is the ieee standard for wireless networking?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

what is bgp, and what its attributes (thanks to sahin he sende me notes) Please try to give answer it will help you in future. after giving the answer most of them i am selected foro\ 2nd round of interview thanks

2 Answers   IBM,


Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  


Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers  


Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

1 Answers  


Which port numbers are used by TCP and UDP to set up sessions with other hosts? A.) 1024 and above B.) 6 and 17 respectively C.) 1-25 D.) 6-17

6 Answers  






What are the differnt memory use in cisco router?

0 Answers  


What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

1 Answers  


Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

1 Answers  


Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack

1 Answers  


Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?

0 Answers  


What is the role of the LLC sublayer?

0 Answers  


What is the beaconing?

0 Answers  


Categories