How to see the running-config & startup-config infor from
global configuration mode.
As we know, from priviledge mode we cn see it by executing
command. i.e.
Router#show running-config
and
Router#show startup-config
Now wat is the coommands use in global configuration mode o
see those info.
Router(Config)# ??????
- 4 Answers
- 6367 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
How many fillers we can put in one ip of ipv6?
What are packets?
Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -
How many types of IP routings?
14 Answers CK, TCS,
Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash updates D.) 60 periodic updates E.) Poison reverse
Do you know how many types of data?
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
Does a bridge divides a network into smaller segments?
What is the key advantage of using switches?
What is the Function of Layer3 Switch?
Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols
Which statement is true when a broadcast is sent in an Ethernet/802.3 ITAN? A. The ip shored used is 255.255.255.0 B. The IP address used is 255.255.255.255 C. The MAC address used is 00 00 00 00 00 00 D. The MAC address used is FF FF FF FF FF FF
CCNA 
