Answer / dharmendra kumar soni

CISO is the best field for network engineer if you want to
do go ahead no discussion anybody bez this is better of all
courses.You shold have graduate,book toddlamle for begning
prepration.But after completed ccna you will have done ccnp
or ccna security or ccna voice ......................Then
you will get better opportunity for job.



Thanks

Answer / roshan singh

CISCO is the best field for network engineer. You shold
have Diploma in Electronic Engineering or B.Tech in EC,
book toddlamle for begning prepration.
Then you will get better and better opportunity for job.

When written <cr > what does it mean?

0 Answers  

---

Which command line statement determines the number of seconds a dialup connection can wait without any traffic before the router hangs up? A.) dialler max-time B.) dialler timeout C.) dialer idle-timeout D.) dialer hang-up E.) disconnect-timer

2 Answers  

---

Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!

5 Answers  

---

Your network uses a Class C address of 210.10.10.0. You must now split up the network into separate shores to handle multiple buildings separated by routers. Which two steps must you take to determine the proper shored mask for your networks? (Choose two) A. determine the number of seperate networks required B. determine how many devices will require DHCP addressing C. determine the maximum number of hosts that will be on each shored D. determine the miniumum number of hosts that will be on each shored E. determine which router will be the IP default gateway for each shored

1 Answers  

---

What are the ranges for the private ips?

0 Answers  

---

Which command switches from User mode to Privileged mode? A.) login B.) privilege C.) admin D.) enable E.) enter F.) root

5 Answers  

---

what is the diffination of bandwidth.

2 Answers  

---

Mention what does the clock rate do?

0 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0

2 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

2 Answers  

---

What is the difference between dynamic NAT and NAT overloading

4 Answers  

---