Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic

1 Answers  

---

What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port

1 Answers  

---

what is prefix list

0 Answers   Infosys,

---

Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down

0 Answers   Infosys,

---

What is icmp protocol?

0 Answers  

---

The PDU at the network layer is a ________ Packet Frame Segment Bit

5 Answers  

---

You have a Class B network address divided into 30 subnets. You will add 25 new subnets within the next year. You need 600 host IDs for each subnet. Which subnet mask should you use? A.) 255.254.0.0 B.) 255.192.0.0 C.) 255.255.252.0 D.) 255.255.248 0

1 Answers  

---

In order to limit the quantity of numbers that a system administrator has to enter, Cisco can use which abbreviation to indicate 0.0.0.0? A. host B. any C. all D. include

1 Answers  

---

What is the protocol and what is the purpose of the following address? 238 255 255 255 A. IPX a SAP broadcast B. IP a multicast group C. IP a reserved address D. IP a directed broadcast E. IPX a flooded broadcast

3 Answers  

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers  

---

FastEthernet compares to 10baseT Ethernet in which of the following ways

1 Answers  

---

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  

---