Answer / guest

Answer: C

Operation of two PC connecting with brand new switches. (they expecting step by step arp ,broadcast,MAC table, RARP operation)

2 Answers   HCL,

---

Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :

2 Answers  

---

If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through

1 Answers  

---

how will configure Nat

6 Answers   Spanco,

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

1 Answers  

---

Which of the following will show an extended access list 150? A.) sh access-list B.) sh ip int C.) sh ip access-list 150 D.) sh access-list 150 extended

1 Answers  

---

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verifies connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  

---

Explain the difference between flsm and vlsm?

0 Answers  

---

When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised

8 Answers   Wipro,

---

Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!

5 Answers  

---

What is point-to-point protocol in ccna?

0 Answers  

---

What is ccna?

0 Answers  

---