What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

1 Answers  

---

Explain the types of nat?

0 Answers  

---

What type of transmission bus topology support?

0 Answers  

---

What is ccna?

0 Answers  

---

Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for IGRP or RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router

1 Answers  

---

what are the different symmetric algorithms?

0 Answers   CCIE,

---

What are some standards supported by the Presentation layer?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

Identify 3 Fast Ethernet technologies? A.) 100 Base FastEther B.) 100 Base FX C.) 100 Base T4 D.) 100 Base TX

2 Answers  

---

What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count

2 Answers  

---

Which decision called socket base?

0 Answers  

---

Describe ICMP messages

4 Answers   HCL,

---