Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 3 key features of the Cisco Discovery Protocol?
A.) Off by default
B.) Will allow for the discovery of layer 3 addresses on
neighbor routers
C.) Verifies connectivity
D.) Open standard
E.) Does not require any layer 3 protocols to be configured
- 1 Answers
- 6613 Views
- I also Faced
- E-Mail Answers
which of the following address represent unicast address A 224.1.5.2 B ffff.ffff.ffff.ffff C 192.168.24.59/30 D 255.255.255.255 E 172.138.128.255 plz tell what should be answer plz tell with explanation
What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device
If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through
How many potions of ip?
How to crimping cat cable without using crimping and any tool...........?
What is the bandwidth capacity of one ISDN B channel A. 64 kbps B. 128 kbps C. 512 kbps D. 1.54 mkbps
Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down
What is wide-mouth frog?
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
How arp brings mac address for switch?
Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)
What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards
CCNA 
