What are the netbios and netbeui?

0 Answers  

---

What we called 64 bit mac-address in ipv6?

0 Answers  

---

2. What are the valid ways to segment a LAN? (Choose all that apply) A. Repeater B. Bridge C. Switch D. Router

2 Answers  

---

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

1 Answers  

---

How does Hold-downs work?

0 Answers  

---

What command would show the version of the IOS that you are running? A.) show nvram B.) show version C.) show startup-config D.) show ios E.) ver -a F.) show ram

1 Answers  

---

What does a router do with a packet that it does not have a destination network for? A.) Sends it to the Serial port B.) Drops the packet C.) Sends it back out the same interface it received it in D.) Forwards the packet to the next hop

2 Answers  

---

Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol

1 Answers  

---

You are a network administrator and have been assigned the IP address of 201.222.5.0. You need to have 20 subnets with 5 hosts per subnet. What subnet mask will you use? A. 255.255.255.248 B. 255.255.255.128 C. 255.255.255.192 D. 255.255.255.240

2 Answers  

---

HI friends mine one of the friends have ask a good question i also donot know the answer so i am putting here Please poet the answer no matter it is wright or wrong put yours view here The question is like that when we are going to configure ospf then there are three way 1st way router ospf 10 netwrok 192.168.1.0 0.0.0.255 area 0 network 192.168.2.0 0.0.0.255 area 0 the 2nd way is like that router ospf 10 netwrok 192.168.0.0 0.0.255.255 area 0 but he inrodused the thrird way like router ospf 10 netwrok 192.168.00000001.0 < ?.?.?.?>area 0 router ospf 10 netwrok 192.168.00000010 <?.?.?.?>area 0 now problem is that what should i put the mask in this way so i puted ? sign Please solve this problem i think this is good one plz donot see for answer please contribute any thing i am reqesting Than you Jitendera kuamr sinha

5 Answers  

---

Explain the term 'multicast'.

0 Answers  

---

To monitor ipx traffic on a network, what command would you use? A. debug ipx transaction B. show ipx traffic C. show ipx events D. display ipx traffic

3 Answers  

---