Interested to Buy Any Domain ? << Click Here >> for more details...
Which configuration task must you complete if a remote Frame
Relay router does NOT support Inverse APP?
A.configure static maps
B.define an IP address locally
C.disable DHCP on the Frame Relay router
D.configure a static route to the remote network
- 1 Answers
- 6676 Views
- I also Faced
- E-Mail Answers
What command displays only OSPF routes?
What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping
Tell me when we use extended access-list?
What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface
Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP
What is the correct command line syntax for configuring a port on a 7000 or 7500 series Cisco router with a VIP card? A.) port B.) port adapter/port C.) You can't put a VIP card in a 7000 or 7500 router. D.) slot/port-adapter/port E.) slot/port F.) slot
Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP
what the exact definition of Ethernet.plz reply as soon soon as possible
What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.
After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1
Which command enables directly connected network 199.55.72.0 to be used by RIP? A. Router(config router)# rip 199.55.0.0 B. Router(config router)# rip 199.55.72.0 C. Router(config router)# network 199.55.0.0 D. Router(config router)# network 199.55.72.0
Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-
CCNA 
