How many broadcast domains are in switch?

0 Answers  

---

Identify the command to configure ALL the default VTY ports? A.) Router(config)# line vty 0 4 B.) Router# line vty 0 4 C.) Router(config)# line vty D.) Router(config)# line vty 0

2 Answers   Accel, CMS,

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

What field tells the Internet layer how to handle an IP packet? A. Type of Service B. Identification C. Flags D. Frag Offset

1 Answers  

---

Explain the draw back of ospf protocol?

0 Answers  

---

Windowing is a type of : A.) Negative acknowledgement B.) Address resolution C.) Layer transition mechanism D.) Flow control

1 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

what is stub router

11 Answers   Satyam,

---

Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigning the IP address 192.168.100.0 to an interface

1 Answers  

---

Hello every one. Please can any one explain me the difference b/w Cisco Switch/ws-c3560-24ps-s and Switch/ws- c3560-24ts-s. what is does PS & TS Stands for. Waiting for your passtive reply. Wish You all the best

2 Answers  

---

Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25

1 Answers  

---

how to troubleshoot when protocols is down and link is not getting up

7 Answers   HCL, Sify,

---