Interested to Buy Any Domain ? << Click Here >> for more details...
In regards to the OSI seven-layer model, at which layer is
EBCDIC
and ASCII?
A.) Presentation
B.) Application
C.) Transport
D.) Session
E.) Datalink
F.) Network
- 1 Answers
- 3835 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
The OSI Presentation layer includes EBCIDIC, ASCII, PICT,
GIF, MIDI, and
MPEG.
Encryption can also occur at this layer.
| Is This Answer Correct ? | 3 Yes | 0 No |
what are the different asymmetric algorithms?
what is full form of rst,smtps & http?
What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A
A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater
How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64
Explain the difference between routing and routed protocols?
What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable
Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'
Explain types of communication in ipv4?
I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1
What is the difference between simple authentication and md5?
Does a bridge divides a network into smaller segments?
CCNA 
