Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  

---

Which can be true regarding VLANs? A.) They are created by location B.) They are created by function C.) They are created by department D.) They are created by group

1 Answers  

---

What is the size of ipv6?

0 Answers  

---

You want to segment a network. The network is running SNA and Netbios. Which device should NOT be used to segment the network? A.) A store and forward switch. B.) A router. C.) A Catalyst 5000. D.) A cut-through switch. E.) A bridge.

1 Answers  

---

Mention what is the difference between dynamic ip and static ip addressing?

0 Answers  

---

A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,

---

Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in

1 Answers  

---

Identify the true statement regarding subnetting? A.) Allows for more host address B.) Borrow bits from the network portion of the address C.) Allows for unlimited number of networks D.) Borrow bits from the host portion of the address

1 Answers  

---

The benefits to segmenting with Bridges are which of the following? A.) Scalability B.) Datagram filtering C.) Manageability D.) Reliability

1 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---

Which statement about half duplex Ethernet operations is true? A. With half duplex transmission frames feed into a single cable in one direction at a time. B. Half duplex transmission between stations is achieved by using point to point Ethernet and Fast Ethernet connections C. Half duplex transmission between stations is achieved by using point to munificent Ethernet and Fast Ethernet connections D. Half duplex Ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end of the connection

5 Answers  

---