What must be true for two Routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D)Configured for PPP

3 Answers   Allied Group,

---

To which layer ICMP belongs

7 Answers   CMS,

---

Which of the following is True regarding passwords on a Cisco router? A. All passwords can be encrypted B. All passwords can be entered using the set-up dialogue C. A password can be set before a user can enter the privileged mode D. A password can be set for individual lines E. TACACS or Radius password authentication can be used.

1 Answers   TATA,

---

Explain what is overlaod?

0 Answers  

---

To prevent Service Advertisements (SAPs) from flooding a network, Cisco routers do not forward them. How are services advertised to other networks? A. Each router builds its own SAP table and forwards that every 60 seconds. B. Each router assigns a service number and broadcasts that. C. SAPs aren't necessary with Cisco routers. D. Cisco routers filter out all SAPs.

1 Answers  

---

Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub

4 Answers  

---

If bandwidth will increase what will happen?

0 Answers  

---

Which of the following do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE

1 Answers  

---

What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device

3 Answers  

---

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number

2 Answers  

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---