Answer / hitesh

We can't shutdown a router from CLI.
But wo can restart it from following command:

Router>
Router>en
Router#
Router#reboot
and then press enter.

Differentiate User Mode from Privileged Mode?

0 Answers  

---

Hi Gyes, here is new question. can you provide answer of following question Like linux, can we windows as router? If yes how can we able to do this,

2 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic

1 Answers  

---

What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers  

---

Which ISDN specification series deals with Concepts and Terminology? A.) C- Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series

1 Answers  

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

hi friends i have a problem.plz solve this. i am working some where and i have the number of swtitch.once my project manger says that we are going to exapnd our number of employ so plz attech an another switch.i asked to my jr network engineer that take a witch and implemnt on that n/w,as he implement the switch on that n/w.thats network get down, plz tell me what is the reason of that.

2 Answers  

---

Name the vtp modes?

0 Answers  

---

What is the main advantage of using switches?

0 Answers  

---

Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config

8 Answers   HCL,

---

which portecol is faster tcp udp spx

8 Answers  

---