Answer / guest

D. 3640

Which of the following three protocols replace SDLC? A. 802.2 B. HDLC C. QLLC D. X.25

1 Answers  

---

Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes

1 Answers  

---

When designing a flat switched network you can have: A. the same number of IP and IPX nodes without performance degradation B. more IP than IPX nodes on the same segment C. more IPX than IP nodes on the same segment D. more AppleTalk than IP nodes on the same segment

1 Answers  

---

What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer

1 Answers  

---

Which address is updated at each hop in the path in path switching?

1 Answers  

---

What are the four basic components of an AppleTalk network? A. Sockets B. Nodes C. Networks D. Areas E. Zones

1 Answers  

---

A remote user needs a static IP address to support a specific application.Which remote access VPN addressing technique supports this ?

2 Answers   Pari Networks,

---

What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP

1 Answers  

---

How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !

1 Answers  

---

What should be looked at first to determine if a customer should switch from a hub environment to a switched environment? A. Investigate the number of broadcasts B. Investigate the number of collisions C. Determine what routing loops are present D. Determine which switching type is being used by the hubs

1 Answers  

---

Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above

1 Answers  

---

Client traffic is being bridged trough LAN interfaces on two WLCs.Which roaming option will Keep them on the same IP Subnet ?

2 Answers   Pari Networks,

---