In an ATM network, which type of device is in a LAN per ELAN
(Emulated LAN)?
A. LAN Emulation Workstation
B. LAN Emulation Router
C. LAN Emulation Server
D. LAN Emulation Bridge
Answer / guest
Answer: C
Multiple ELANs can exist at the same time on a single ATM
network and are made up of an LAN emulation client (LEC), an
LAN emulation server (LES), a broadcast and unknown server
(BUS), and an LAN emulation configuration server (LECS).
Is This Answer Correct ? | 1 Yes | 0 No |
Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
What PPP frame initiates the network layer protocols to be used during a connection?
Which Of the Statements best describes VPLS ?
6. Which of these statements best describes VPLS ?
How many networks will be advertised using route summarization within an OSPF network if you are given the following networks? 192.108.168.0 192.108.169.0 192.108.170.0 192.108.171.0 192.108.172.0 192.108.173.0 192.108.174.0 192.108.175.0 A. 1 B. 2 C. 3 D. 4 E. 5
What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer
What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP
When would you suggest static routes to your customers? A. When scalability is important B. When bandwidth is limited C. When the network will be changing frequently D. Always suggest static routes
Diagramming application information flow is important because: A. it helps identify heavy traffic paths B. it helps figure out why email gets from one place to another C. it can tell you when to purchase a new router D. it can tell you when to purchase a new switch
Which address is updated at each hop in the path in path switching?
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration: CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !