Which tools help to characterize a network?
A. Sniffer
B. CiscoWorks 2000
C. Netsys
D. All of the above
- 1 Answers
- 3139 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
All of the above tools can help in characterizing a network.
| Is This Answer Correct ? | 1 Yes | 0 No |
EIGRP was developed to improve what two protocols? A. OSPF B. RIP C. BGP D. IGRP
What would a TE2 device be used for in an ISDN connection? A. as a connection from an NT1 device to an NT2 device B. as a connection from a non-ISDN terminal through a TA to the ISDN network C. as a connection from four-wire subscriber wiring to the conventional two-wire local loop D. as a connection to the ISDN network through a four-wire, twisted-pair digital link
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
Which of the following is not true in regards to route summarization? A. It increases the size of the routing table B. It increases the complexity of the network C. IP networks must be contiguous to be safely summarized D. Routing tables must have the capacity to support classless routing
What device initiates a session in an X.25 network? A. DTE B. DCE C. PSE D. PAD
What are two differences between 10BaseT and 100BaseT? A. Speed B. Frame format C. Addressing D. Network diameter
With Centralized Routing, each node must determine and maintain its routing information independently? A. True B. False
How can change k-value in EIGRP configuration.
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes
What are three advantages of using fiber? A. Security B. Eliminate RFI and EMI C. Low cost D. High speed
CCNA 
