Answer / guest

Answer: C

Answer / surjeet gimit

Answer is C

Answer / s.m.feroz ahmed

Hi,

UserMode.

Answer / kunal

for intial configuration on fresh router it require setup
mode so C would be correct answer.
A copy mode is nothing but used copy cmd in tftf flash
copying ios.
B user mode is for showing utilities and restricted
permissions
D.startup mode is used basic start up[ configuration..well
cisco determines basically 4 modes
1.user mode
2global config mode
3.privilage mode and
4 set mode thats all

Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP

2 Answers  

---

Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended

2 Answers  

---

what is Bandwidth capping

1 Answers   Infosys,

---

What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list

3 Answers   jetking,

---

8. When is Frame Tagging used? A. When you install repeaters in your network B. When you install bridges in your network C. When you install routers in your network D. When you use Switches configured with multiple VLANS

5 Answers  

---

Which command successfully pings an individual IP address? A. Router> ping 192.5.5.0 B. Router# ping 192.5.5.30 C. Router> ping 192.5.5.256 D. Router# ping 192.5.5.255

2 Answers  

---

Most routing protocols recognize that it is never useful to send information about a route back out the direction from which the original packet came. This is an example of which routing technology? A.) Split Horizon B.) LMI C.) Triggered Updates D.) Poison Reverse E.) SYN, ACK F.) DLCI

1 Answers  

---

What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

---

What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?

20 Answers   IBM,

---

Explain what is overlaod?

1 Answers  

---

Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Autonomous system number E.) Link state

1 Answers  

---