What is a Frame Relay?
No Answer is Posted For this Question
Be the First to Post Answer
Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
Which ISDN protocol prefix specifies switching and signalling? A.) I B.) E C.) Q D.) S
Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP
Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash
What does CCNA stand for? A. Cisco Certified Network Administrator B. Cisco Certified Network Associate C. Certified Circuitry in Networking Apprentice D. Calico Cats of North America
Which of the following is an example of the Session Layer? A.) TCP B.) SQL C.) IP D.) X-Windows E.) Token Ring F.) LLC
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
How does PPP use LCP for link control?
Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port