How many collisions are caused by transmitting and receiving
frames simultaneously in a full-duplex Ethernet technology?
A. one
B. two
C. none
D. several
- 1 Answers
- 4367 Views
- I also Faced
- E-Mail Answers
Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config
hi shain can u send me some detail about bgp so that i can enhance my knowledge over bgp and can you also teach me about the process of suppernating. now what i am thinking that this could be last visit on that site overhere.so please mail that short of thing on my gmail id i am requesting to all of the visitor that please send theire doubt or question to my new gmail id which is jitendera.ccnainterview@gmail.com.i will try to solve it if i am capable to do it Wishing all of you for great future Jitendera kaumar sinha
thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.
Given the address 172.16.2.120 and the subnet mask of 255.255.255.0. How many hosts are available? A. 254 B. 510 C. 126 D. 16,372
Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a
How many hope count rip or rip2 can send updates?
What is the difference between the user mode and the privileged mode?
What are the two types of transmission technology available in ccna?
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services
Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not at the same time
Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route
Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :
CCNA 
