can any budy send the steps for enabling snmp on cisco
switches(L2).
There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp
How are internetworks created?
What command would show the version of the IOS that you are running? A.) show nvram B.) show version C.) show startup-config D.) show ios E.) ver -a F.) show ram
Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book
How do areas benefit a link state inter network?
what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain
hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?
Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down
You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.
In static route, what is the difference between next hop ip address and local interface address, except the Administrative Distance.
IP RIP routing is conferred on a router but not all interfaces attach to RIP networks. What should you use to prevent all RIP routing updates from being sent through selecedc interfaces without using access lists? A. passive route B. default routes C. passive interface D. route update filtering
Why Operating System Have only 65,535 port Numbers