The Datalink Layer is broken down into 2 layers, LLC and
MAC. The LLC
establishes media independence and what else?
A.) Provides Windowing.
B.) Provides flow control.
C.) Provides SAP's (Service Access Points).
D.) The Datalink layer does not have sublayers.
E.) Provides SAP's (Service Advertising Protocol).
F.) RIP Updates.
Answers were Sorted based on User's Feedback
Why Operating System Have only 65,535 port Numbers
What is STP and what is the difference between PVST and RSTP
What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
what is the difference between a passive and active hub?? which is better ??
Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) RPC and SQL D.) JPEG and PICT
What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
In how many ways can data be transferred in ccna?
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay