Answer / guest

Answer: C

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Gandalf5 B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) SAP

2 Answers  

---

What is the meaning of PASSIVE interface in RIP, IGRP, EIGRP & OSPF?? Can any one explain..!!!

6 Answers  

---

What is a back off on an 802.3 networks? A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. It is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged

1 Answers  

---

in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please

4 Answers  

---

Define routing?

0 Answers  

---

Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's

2 Answers  

---

What is the correct command line syntax for configuring a port on a 7000 or 7500 series Cisco router with a VIP card? A.) port B.) port adapter/port C.) You can't put a VIP card in a 7000 or 7500 router. D.) slot/port-adapter/port E.) slot/port F.) slot

1 Answers  

---

Hi Anyone can share the latest ICND1 (640-822)dumps updated at 30 september 2009. specialy to Jatendra if you have any updated about the ICND1 exam.will be remain thankful.

2 Answers  

---

Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp

3 Answers   CMS,

---

What should be the first command to create an access-list that prevents all users on subnetwork 10.10.128.0, using subnet mask 255.255.192.0, from being able to telnet anywhere? A.) access-list 101 deny tcp 10.10.128.0 0.0.63.255 any eq telnet B.) access-list 101 deny tcp 10.10.128.0 255.255.0.0 any eq telnet C.) access-list 101 deny tcp 10.10.128.0 255.255.192.0 any eq telnet D.) access-list 101 deny tcp 10.10.128.0 0.0.192.255 any eq telnet E.) access-list 101 deny tcp 10.10.128.0 0.0.128.255 any eq telnet F.) access-list 101 deny tcp 10.10.128.0 0.0.127.255 any eq telnet

3 Answers  

---

What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

Explain how many types of router?

0 Answers  

---