Identify 3 characteristics of a connection oriented protocol?

A.) Path determination

B.) Flow control

C.) Acknowledgements

D.) Uses hop count as metric

E.) 3 way handshake

Answers were Sorted based on User's Feedback



Identify 3 characteristics of a connection oriented protocol? A.) Path determination B.) Flow ..

Answer / sanjoy singha

B,C,E tcp is a connection oriented protocol..so 3way
handshaking,acknowledment,flow control shuld be the
characteristics...

Is This Answer Correct ?    1 Yes 0 No

Identify 3 characteristics of a connection oriented protocol? A.) Path determination B.) Flow ..

Answer / guest

Answer: B D E

Is This Answer Correct ?    0 Yes 2 No

Post New Answer

More CCNA Interview Questions

What hppends when ping 127.0.0.1 command executes?

10 Answers   Wipro, CMS,


Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

1 Answers  


What is the function of the Application Layer in networking?

0 Answers  


What is link aggregration?? How many types of protocol are used on that???

3 Answers   Hathway,


Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

1 Answers  






What is DHCP stand for?

0 Answers  


Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. In order for two ends of virtual circuits to communicate using Frame Relay, their network addresses must be mapped to DLCIs.

2 Answers   Wipro,


If line down and protocol also down; in this case which layer move problem?

0 Answers  


Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash

2 Answers  


FastEthernet compares to 10baseT Ethernet in which of the following ways

1 Answers  


How does L2TP process?

0 Answers   CCIE,


Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route

1 Answers  






Categories