Identify the type of hardware required to connect a Token ring
network to
an Ethernet network?
A.) Repeater
B.) TR-Enet
C.) Router
D.) Token Ring to Ethernet translation hub
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC
Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category
A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater
In version 11.2 of the IOS, a Cisco router configured for frame-relay can automatically detect the LMI type. What is this known as? A.) Psychic B.) ESP C.) Inverse ARP D.) Hello E.) Reverse ARP F.) Autosense
Which line from a show spantree 1 command output indicates that virtual LAN 1 (VLAN1) is functioning properly? A. Root pod is FastEthernet 0/26 B. Port Ethernet 0/1 of VLAN1 is Forwarding C. Designated port is Ethernet 0/1, path cost 10 D. Designated root has priority 0 address 00D0 588F B600 E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains
Define load balancing?
Fried i am jitendera here.i donot know this is ccna question or not but i need some help friend i am in love and i donot know how to propose.this is my felling that she also like me but she want that i have to prosed first i am little bit shy boy how cam i propose without risk please answer this question befor any another person propose her please please please
IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address
Is it possible that in a switched network that any port of the switch can be infected with any kind of viruses that jamed and create more traffic in network which cause slow network performance?