Answer / guest

Answer: C

Answer / girirajan

b.)16

friends i have 3ree prob which is asked in ibm india in technical round 1 what is ftp(this was easy i had answered) 2 why we use ftp(i think it is a tough one) 3 how can we enable ftp in the widows xp. friend i need these question answer as soon as possible if it is possible to reply within the eveing then i always obeyliged to you i am espacily looking towards the jitendera sinha who make most of the valuable answer loking toward you nidhi mall

3 Answers   IBM,

---

What is subnet? Why is it used?

1 Answers  

---

Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed

1 Answers  

---

What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Which can be true regarding VLANs? A.) They are created by location B.) They are created by function C.) They are created by department D.) They are created by group

1 Answers  

---

What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

2 Answers  

---

How arp brings mac address for switch?

1 Answers  

---

Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route

1 Answers  

---

Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector

2 Answers  

---

When using RIP, routing updates are broadcast every ____ seconds. A. 30 B. 10 C. 60 D. 90

4 Answers  

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers  

---