Can you explain tunneling?
- 1 Answers
- 2090 Views
- CCIE, I also Faced
- E-Mail Answers
Answer / Tulsi Ram Yadav
Tunneling is a method of encapsulating one network protocol inside another to transmit data over a network where the encapsulated protocol may not be supported.
| Is This Answer Correct ? | 0 Yes | 0 No |
What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward
There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton
What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds
What is segmentation and fragmentation?
Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
What is half duplex and full duplex?
Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash
You want to segment a network. The network is running SNA and Netbios. Which device should NOT be used to segment the network? A.) A store and forward switch. B.) A router. C.) A Catalyst 5000. D.) A cut-through switch. E.) A bridge.
Which of the following is an example of the Datalink Layer? A.) LLC B.) TCP C.) SQL D.) IPX E.) Token Ring F.) MAC
How many (minimum and maximum) ports are present in a router?
Can you explain the basic of encryption in VPN?
CCNA 
