What is the default behavior of access-list?

0 Answers  

---

What is the difference between full duplex and half duplex?

0 Answers  

---

hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha

0 Answers   ALU, TATA, Volvo, Wipro,

---

Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi

1 Answers  

---

In distance-vector routing, there is a problem known as the 'count to infinity' problem. What is the most direct solution to this? A.) Defining a Maximum. B.) You can not solve the 'count to infinity' problem with a distance vector protocol. C.) Poison Reverse. D.) Triggered Updates. E.) Split Horizon.

2 Answers  

---

Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199

1 Answers  

---

what are the different asymmetric algorithms?

0 Answers   CCIE,

---

What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs

2 Answers  

---

How many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers  

---

What command do you use to disable domain lookup? A.) no domain-lookup B.) domain no-lookup C.) lookup no-domain D.) no ip domain-lookup

2 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---

What command displays the OSPF Process ID, Router ID, Address summarizations, Routing Networks, and passive interfaces configured on a router?

1 Answers  

---