Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 3 pieces of hardware you would not install to
prevent
broadcasts?
A.) Switch
B.) Repeater
C.) Bridge
D.) Router
- 3 Answers
- 10891 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / m haja bahurdeen
Ans : A,B,C
Switch - prevent collision domain
Repeater - Repeat the weak signal and reduce the noise signal
Bridge - operation same to switch
Router - prevent broadcasts domain
| Is This Answer Correct ? | 10 Yes | 0 No |
You have just issued the erase startup-config Command and reloaded your router. In which mode will your router be when you react? A. setup B. startup C. user EXEC D. userd privileged E. global configuration
UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link
Which command will show you if you have a DTE or DCE cable connected to an interface?
What is the Broadcast IP Address?
The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111
What are the different IPX access lists?
Identify the effect of Ctrl-Z? A.) Exits back to privileged exec mode B.) Disconnect from the router C.) Abort the ping operation D.) Exits privileged exec mode
Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in
What route entry will be assigned to dead or invalid route in case of RIP?
Which Circuit is mostly used by Clients in Frame-Relay PVC or SVC ?
Differentiate full-duplex from half-duplex.
what is used for passive intercae comand mine answer-to prevent to take update from outside
CCNA 
