What are the two components of an IPX address?
A. network number IP address
B. MAC address node number
C. network number MAC address
D. network number arched number
- 1 Answers
- 4143 Views
- I also Faced
- E-Mail Answers
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
In order to enable RIP, which two tasks need to be performed? (choose two) A. Specify the routing protocol B. Confound static RIP routes C. Specify directly connected subnets D. Specify directly connected networks
What will be the prefix length of 224 in vlsm?
Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP
A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?
Which protocol works only on cisco routers?
What is a vlan?
What command do you use to disable domain lookup? A.) no domain-lookup B.) domain no-lookup C.) lookup no-domain D.) no ip domain-lookup
What's the default CDP holdtime in seconds for Cisco routers? A.) 30 seconds B.) 180 seconds C.) 90 seconds D.) 60 seconds
Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport
Identify the command that displays ethernet0/1 interface status? A.) show interface ethernet0/1 B.) show interface ethernet e0/1 C.) show interface ethernet0.1 D.) show ethernet0/1
routing information
CCNA 
